Can the DAPLINK be used to program a generic nRF52832 IC?


#1

I tried to program a custom made board with the nrf52832 IC with the daplink through arduino and got these error while trying to burn the bootloader. Is there a way to do this ?

Open On-Chip Debugger 0.10.0-dev-00254-g696fc0a (2016-04-10-10:13)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
debug_level: 1
adapter speed: 10000 kHz
cortex_m reset_config sysresetreq
Error: Could not find MEM-AP to control the core
Error: Could not find MEM-AP to control the core
Error: Target not examined yet
in procedure ‘reset’
in procedure ‘ocd_bouncer’

Error while burning bootloader.

Connections were made same as the BLE nano module to DAPLINK


#2

hi praga
what is the version of your Daplink. And you should select the accurate port and board and follow the Install Board Package first


#3

And Did you choose the programmer as RBL_Daplink in the Tools->Programmer