Load cell - blend micro


#1

Hi all,

I’ve been working with a load cell, arduino uno and bluetooth and went for the blend micro for the next phase. However, I can’t get the application to work. I’m not all that clued up on the electronics side, but on my old setup I was connecting to the 5V, gnd, A0 and A1 pins.

a) iss this possible with the blend micro, when yes b) what pins are what? A look at the pictures and docs hasn’t helped me thus far.

Thanks id advance.


#2

Try connecting the power source to the VIN pin on the BlenMicro and leaving others as the same as your old prototype.