Uploading sketch via Arduino IDE to RedBear Duo Native Port fails with avrdude: Expected signature for cortex-m3 is 1E 90 0B


#1

My Duo runs on 0.3.1 - same as the IDE, and I get the error below, when uploading sketch.

Build options changed, rebuilding all
32+0 records in
32+0 records out
32 bytes copied, 0.0171571 s, 1.9 kB/s
4+0 records in
4+0 records out
4 bytes copied, 0.0505997 s, 0.1 kB/s
Sketch uses 4088 bytes (1%) of program storage space. Maximum is 262144 bytes.
Found programmer: Id = “RBL-DUO”; type = S
Software Version = 1.0; Hardware Version = 1.0
Programmer supports buffered memory access with buffersize=64 bytes.

avrdude: Expected signature for cortex-m3 is 1E 90 0B
Double check chip, or use -F to override this check.
avrdude: error: programmer did not respond to command: leave prog mode
avrdude: error: programmer did not respond to command: leave prog mode

The upload works when I use the RBLink.


#2

Hi @pedda, What is the version of the Arduino IDE you are using? The Arduino 1.6.7 works well for the Duo.


#3

Hi,
I am using the latest 1.8.1. I will checkout the 1.6.7 version but not until next tuesday.
Thanks for the advice!


#4

Hi there,

I have the same problem for my duo board. Do you have any solutions?

Thanks


#5

Hi @hl1,

Are you using Arduino IDE 1.6.7? And what is the firmware version of the Duo you are playing with?

Best regards,
Guohui


#6

Hi there,

I am using the latest Arduino1.8.5 (also tried 1.8.0) under linux. I think firmware is also latest 3.1. I will try under windows once I got time.

Thanks